Verifying the Configuration

After the AP has been configured, navigate toDashboardpage and verify that the AP has anupstatus. The AP on your networkdoes notappear in this table, it may have been classified as an inactive AP for any of the following reasons:

The AP is configured with a missing or incorrectVLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN.。配置(例如,美联社e a tunneledSSIDService Set Identifier. SSID is a name given to a WLAN and is used by the client to access a WLAN network.ofVLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN.2 but thecontrollerdoes not have aVLANVirtual Local Area Network. In computer networking, a single Layer 2 network may be partitioned to create multiple distinct broadcast domains, which are mutually isolated so that packets can only pass between them through one or more routers; such a domain is referred to as a Virtual Local Area Network, Virtual LAN, or VLAN.2.)

The AP has an unknown AP group.

The AP has a duplicate AP name.

An AP with an external antenna is not provisioned with external antenna gain settings.

Both radios on the AP are disabled.

No virtual APs are defined on the AP.

The AP has profile errors. For details, access the command-line interface and issue the command “show profile errors”.

TheGREGeneric Routing Encapsulation. GRE is an IP encapsulation protocol that is used to transport packets over a network.tunnel between the AP and themanaged devicewas blocked by afirewallFirewall is a network security system used for preventing unauthorized access to or from a private network.after the AP became active.

The AP is temporarily down while it is upgrading its software. The AP will become active again after upgrading.